How to Install Zest Wall Panels

Zest wall panels are the perfect combination of style and practicality. They are also extremely easy to install. This blog will take you through the process of installation from what tools you'll need and how to prepare your walls to measuring, cutting, and fixing your new Zest wall panels, hopefully resulting in a professional, seamless finish.

Tools and Materials You'll Need

To install your new Zest wall panels using adhesive, you will need the following tools and materials:

• Either a hand saw, circular saw or jigsaw all with a fine-tooth blade
• Stanley knife
• Tape measure and pencil or marker
• Adhesive and adhesive gun
• Spirit level
• Slat Wall Panels

Step-by-Step Guide: How to Install Zest Wall Panels

Once you have your tools and materials, you can start installing your new slat wall panels.

Step 1 - Prepare the Wall

Before you start your installation, you need to prepare your walls. Start by removing any debris, screws and nails. You can then clean the surface with a damp cloth. It is important to ensure that the wall is completely flat, even, and dry before you start installing your new Zest panels.

Step 2 - Plan Your Layout

Planning your layout and where you want your panels to be placed may sound obvious, but it's a very important step. Once you know where you want your panels to go, you need to measure the wall. Do this by measuring the height and width of the area where you plan to install the wall panels. Mark these measurements on the back of the panel to denote where you need to cut.

Step 3- Cutting the Panels

Use a hand saw, circular saw, or jigsaw to cut your Zest wall panels. To ensure a straight, clean cut, place a strip of masking tape along your marked line. A Stanley knife is useful to accurately cut the felt on the back of the panel. Always cut the panel with the front face of the panel facing down and use 180 grit sandpaper to smooth away any rough edges.

Step 4 - Applying Adhesive

Once you've made your cuts and have placed the panel in situ without adhesive and are happy with the fit, you can apply your adhesive. We recommend applying this in a zig zag pattern on the back of the panel, ensuring it is evenly spaced. A top-quality grip and grab solvent free adhesive is a good choice for this type of wall panel installation.

Step 5 - Fitting the Panels

Once the adhesive is applied, you can lift the panel into position maybe with a little bit of help! You will be installing the panels from left to right or bottom to top, depending on your desired orientation. Make sure you keep it straight as you press it against the wall and apply gentle pressure to ensure the adhesive adheres. Now, hold it in place to allow the adhesive to set. After fitting your first panel, check the horizontal or vertical alignment with a spirit level to ensure it is straight. Now you can attach your second panel. However, before pressing the panel onto the wall you need to make sure there is no gap between the panels. Also, it is a good idea to check the vertical or horizontal alignment again after each panel is installed.

Step 6 - Dealing with Sockets & Fixtures

If your panels need go around sockets or fixtures, measure and mark the position of each on the back of the panel. Using a Stanley knife for the felt and a small hand saw for the wood slats; you can cut around each marked position. Sand down any rough edges for a smooth finish. For the proper installation of a plug socket or light switch, you will need to use the correct electrical box. A spacer ring should then be added to the box which will allow for the cables to run the depth of the panel safely. The socket can then be screwed directly into the panels and wall to support the fixture.

Hopefully this step-by-step guide has provided you with an overview of how to install your new Zest Wall Panels. However, if you have any queries about how to install Zest wall panels or would like further information about the Zest range of acoustic panels, call our expert team today on 0800 22 77 77.